What you get…

Storage box

  • Storage Box Ends

  • Storage Box

Coral Cot, Heater, Pump, Light and Controllers

  • Tank and Lid

  • Heater, Pump, Light and Controllers

  • Tank Stand

  • Regional Plug

  • Heater Holder

Accessories

  • Quick Prime Syphon

  • Adjustable Frag Holder

  • Dosing Pipette

How It Works in Words...

  • You’ll get the light, pump, and heater connected to the control box in the tank, and the tank inside the stand.

    In the accessories box you’ll find the USB plug, adjustable frag stand, the quick prime syphon, pipette to help dosing and feeding, and the suction holder for the heater.

  • Attach the light to the stand and the pump and heater to the tank. feed the wires into the back of the stand to hide them

  • Prime the syphon by opening the valve and then either:

    1. dunking the tubes into your tank so the tubes fill with water then close the valve to trap the water, It’s primed!

    2. Pour salt water into the pipes to fill them up then close the valve, It’s primed!

    3. Fill the tubes directly from the tap then close the valve. Finally syphon out a tank to get rid of the tap water, It’s primed!. Don’t let the tap water get into any tanks!

    Easy!

  • Put the coral in the Coral Cot tank (with the water it came in if you like). Use the syphon to add fresh salt water.

  • Enjoy the new coral and dip and treat as needed.

  • When you’re happy with your coral pop it in your tank!

  • Put the light, heater, pump, and all wires and the controller into the tank, then the tank into the stand, and all the accessories into the accessories box. Then put the accessories box, tank, and stand back into the box. Close the box, put the box ends back on, and store it away until next time!"

Unbox the bits

You’ll get the light, pump, and heater connected to the control box in the tank, and the tank inside the stand.

In the accessories box you’ll find the USB plug, adjustable frag stand, the quick prime syphon, pipette to help dosing and feeding, and the suction holder for the heater.

Assemble the tank

Attach the light to the stand and the pump and heater to the tank. feed the wires into the back of the stand to hide them

Let’s Syphon!

Prime the syphon by opening the valve and then either:

Option 1. Pour salt water into the pipes to fill them up then close the valve, It’s primed!

Option 2. dunk the tubes into your tank so the tubes fill with salt water then close the valve to trap the water, It’s primed!

Option 3. Fill the tubes directly from the tap then close the valve. Finally syphon out a tank to get rid of the tap water, It’s primed!. Don’t let the tap water get into any tanks!

Easy!

Put your new coral in the Coral Cot!

Place the coral into the Coral Cot tank (you can include the water it arrived in, if preferred). Use the siphon to add fresh saltwater.

You can easily adjust the height of the frag holder, or remove the insert entirely to accommodate frag plugs with wider stems. If necessary, you can also add small stones to the bottom of the tank to help weigh down and secure the coral plugs.

Enjoy your new Coral But watch what happens...

Enjoy your new coral! Make sure to dip and treat it as needed. You can use the included pipette to feed the coral, collect water samples for testing, or dose the tank—all without needing to remove the lid.

The siphon can be used for both partial and complete water changes. Important: If you are performing a complete water change, please turn off the pump and heater first to prevent any damage to the equipment.